Medisana MTC Operations Instructions download pdf (Page 23)

5 Memory / 6 Miscellaneous

5.2

Deleting memory

6.1

Troubleshooting

If the voice function has been activated, the device speaks the memory

location number, together with the saved blood pressure and pulse values and

the blood pressure assessment as per the scale in the World Health Organisa-

tion guidelines (see pg. 13).

Repeatedly pressing the MEM button



displays the respective values

measured previously. In memory recall mode, the unit will switch off auto-

matically after approx. 120 seconds if the last entry has been reached and no

button is pressed. Memory recall mode can be exited at any time by pressing

the START button



, which will also switch the unit off.

If all 60 memory locations in the memory are occupied, a new measured value

is saved whilst the oldest value is deleted.

If you are in memory recall mode, press and hold the MEM button



for

approximately 8 seconds. All measured data stored will be deleted automati-

cally after three beeps. Only noughts will be shown on the display instead of

the measured values.

The battery change symbol appears in the display

• The batteries are too low or empty. Replace all four batteries with new 1.5 V

alkali AA batteries.

Erratic measurements being displayed

• Cuff incorrectly fitted or not tight enough. Fit cuff correctly and tighten.

• You have changed position or the cuff has moved during the measurement.

Keep still and do not move your arm or the cuff.

• You have an irregular heartbeat. Even if your heartbeat is only slightly

irregular, repeat the measurement. The unit is not suitable for people with

an extremely irregular heartbeat.

• You have spoken during the measurement, you are nervous or you are

excited. Do not speak and breathe deeply two or three times in order to

relax.

• You are not in the corrected seated or lying position. Please assume the

correct position when taking the measurement.

• The air hose is not connected or leaking. Check the connection between the

upper arm cuff and the unit and check the air hose for leaks. Repeat the

measurement.

“EE” appears in the display

• The unit has not been inflated enough. Repeat the measurement

• A problem occurred during inflation or during the measurement. Repeat the

measurement.

No display or display locked

• No batteries have been inserted, batteries wrongly inserted or batteries are

completely empty. Insert batteries, check battery position or replace with

new batteries.

• A malfunction or fault has occurred. Briefly remove the batteries and then

replace them.

Please contact the service centre if the error message appears again

when the measurement is repeated.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 109 110

Comments to this Manuals

No comments

Medisana MTC Operations Instructions Page 23

Comments to this Manuals

Related products and manuals for Blood pressure units Medisana MTC