Medisana HGN User's Guide download pdf (Page 36)

5.1

Displaying

stored results

5.2

Deleting

memory

Up to 60 measurements (blood pressure and pulse with time and date) may be stored in each of

the blood pressure monitor’s two memories. The measured values are stored automatically. Press

the MEM button



to call up the measured values stored. The unit displays the memory set (U1

or U2). Pressing the START button



switches to the other memory. The values of the most

recently saved measurement (memory location number e.g. “01”) including the flashing blood

pressure indicator are displayed after pressing the MEM button



Repeatedly pressing the MEM button



displays the respective values measured previously. In

memory recall mode the unit switches off automatically after approximately 120 seconds if the last

entry has been reached and the MEM button



has been pressed once more. Memory recall mode

can be exited at any time by pressing the START button



, which will also switch the unit off.

If all 60 memory locations in a memory are occupied, a new measured value is saved whilst the

oldest value is deleted.

If you are in memory recall mode, press and hold the MEM button



for approximately 8 seconds.

All measured data stored will be deleted automatically after three beeps. Only noughts will be

shown on the display instead of the measured values.

5 Memory

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 185 186

No comments

Medisana HGN User's Guide Page 36