Medisana HP 620 Instruction Manual download pdf (Page 16)

3 Miscellaneous

3.1 Troubleshooting

This unit is equipped with the active protection system APS TECH. The unit detects

different causes of errors and emits corresponding alarm sounds if necessary. In the

case of an error, the power LED will light up in red.

3 beeps in 1-second interval and power LED lights up in red:

The connection cable of the control unit is not properly connected to the heat pad or

another electrical defect is present. Please check the cable connection. Is the cable

connected properly, please do not use the heat pad and contact the service center.

3 beeps in 2-second interval for one minute and power LED lights up in red:

The heat pad is broken, folded or fully covered. Please use the heat pad only according

to this instruction manual and pay attention to all points in the safety information

chapter.

Constant beeping and power LED lights up in red:

Important components are damaged or there is a short circuit. Please do not use the

heat pad and contact the service center.

If there is no function at all after switching on the heat pad (power LED shows no

light and no beeps can be heard), please check if the mains plug is correctly plugged in

the mains outlet. If this is the case, the heat pad is defect. Please do not use the heat

pad and contact the service center.

3.2 Cleaning and maintenance

• Before cleaning the pad, unplug it from the mains outlet and let it cool down for at

least ten minutes.

• The heat pad is equipped with a removable control unit. Unplug the control unit from

the heat pad by pulling out the connection cable from the plug on the heat pad.

• The heat pad can be cleaned with a soft brush when dry.

• The heat pad may be carefully washed by hand. Ideally you should place the heat

pad in a bathtub with warm water and a little mild detergent and squeeze it gently.

• Rinse the pad several times to get rid of any remaining detergent.

• Never use strong detergents or hard brushes.

• To dry, lay the pad flat on a moisture-absorbent towel or mat.

• Only use the blanket again once it is completely dry.

• Reconnect the control unit to the heat pad in the correct

manner (please see the sketch, the arrow markings

are showing towards each other).

• You should untangle the cable from time to time.

• Store the unit in a clean and dry place, laid out flat

with nothing covering or resting on top of it.

61151_GA_HP_620_West_04.08_FINAL.qxd:Heizkissen 06.08.2012 8:39 Uhr Seite 12

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 77 78

No comments

Medisana HP 620 Instruction Manual Page 16