Medisana BBS Instruction Manual Page 24

  • Download
  • Add to my manuals
  • Print
  • Page
    / 110
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 23
16
2 Operation
GB
Adjustments on the pump unit
Spa intensity
Press the power button
once. The appliance switches on and starts operating
in the lowest mode (Low) immediately. The Low LED lights up green.
Press the power button
again. Now the Medium LED lights up green. The
appliance now operates in the medium mode (Medium).
Press the power button
a third time. Now the High LED lights up green.
The appliance now operates in the highest mode (Hi).
Press the power button
a fourth time. Now the Program LED lights up green.
The appliance now operates in the automatic interval massage program
(Program). The appliance runs through the three levels of intensity in succession
(Low, Medium, High) and then back to the beginning.
• The next time you press the power button
, the appliance switches off again.
Preset operation time
The timer button
allows you to choose between three time settings: 30, 20
or 10 minutes. It is not advisable to use the appliance for more than 30 minutes
(see safety instructions). Leave an interval of at least 30 minutes before you switch
on the appliance again.
Press the timer button
once. The operation time is set for 10 minutes. The
10 LED starts flashing yellow.
Press the timer button
once again. The operation time is set for 20 minutes.
The 20 LED starts flashing yellow.
Press the timer button
a third time. The operation time is set for 30 minutes.
The 30 LED starts flashing yellow.
Once the preset time has elapsed, the appliance switches off automatically. If no
time has been set, the appliance switches off after 30 minutes.
Switching on the heat function
NOTE
The heat function is not designed for the water temperature or
for heating up a cold bath. Warming the air created by the spa
bubbles, prevents the bath water from cooling down while it is
in use.
If you want to use the heat function, press the heat button
. The LED next to
it lights up red. Press the heat button
again to switch off the heat function and
the LED light disappears.
Adjustments on the remote control
If you want to use the infrared mode
, firstly get into the bath carefully and
switch on the appliance by pressing the power button
on the remote con-
trol.
88382_BBS_West_FINAL.qxd:Luftsprudelbad 08.10.2009 14:45 Uhr Seite 16
Page view 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 109 110

Comments to this Manuals

No comments